Original Factory End Entry Ball Valve - A216 WCB 900LBS Check Valve CVC-00900-6 – Deye

Quick Detail

Design standard: API 600.API594 BS1868

Body material: WCB. Carbon Steel

Nominal diameter: 6”DN150

Pressure: CL900LBS

End connection: RF. Flange

Face to face: ASME B16.10.

Working temperature: -29℃~+425℃.

Test and inspection: API 598.

Full bore Check valves

High Pin Flat Disc Check Valves

Integral Disc check valves

On Request

Available Material: A216WCB/WCC/LCB/WC9/C5/CF8M/CF3

Optional Stem: A182F6a, A182F304, A182F316, F51/F53

Optional Seat & Trim: STL, 2CR13, SS304, SS316/F51

Optional End connection:

Range of valve sizes diameter: 1/2″~60″ (DN15~DN1500).

Range of pressure: 150lbs~2500lbs (PN16~PN420).

Optional: By pass design

Optional Operation: automatic type or Lever and counter weight

Performance:

INSPECTION BEFORE INSTALLATION

1. Before installation, check the valve name plate and valve body information to ensure the valve is suitable for the intended service.
2. Before installation, remove the flange cover and the protective film on the flange sealing face, and disc support, inspect the bore and the flange sealing surface, remove any dirt with clean soft cloth, use an anti-corrosive cleaning liquid to clean if necessary, and never use any other chemical products.
3.  Inspect the flange gasket (including ring gasket) sealing surface and ensure it is in acceptable condition for installation. Install Position the valve into the pipe or the flange connection; ensure that any stress caused by improper pipe alignment is relieved first. Valves are not intended to be a means of aligning improperly fitted pipe.2 Valves marked with flow direction must be installed in line with the piping flow.3 Valve should be installed in a horizontal position with the center of the valve.

    

Application:

The medium is water, steam, gas, corrosive medium, oil, medicine, etc.